3D laser-printed airway saves baby's life

Heartbeat_shutter_120166936

Ann Arbor, MI - April and Bryan Gionfriddo watched helplessly every day as their baby stopped breathing, his collapsed bronchus blocking the crucial flow of air to his lungs.

"Quite a few doctors said he had a good chance of not leaving the hospital alive," says April Gionfriddo, about her now 20-month-old son, Kaiba. "At that point, we were desperate. Anything that would work, we would take it and run with it."

They found hope at the University of Michigan, where a new, bioresorbable device that could help Kaiba was under development. Kaiba’s doctors contacted Glenn Green, M.D., associate professor of pediatric otolaryngology at the University of Michigan.

Green and his colleague, Scott Hollister, Ph.D., professor of biomedical engineering and mechanical engineering and associate professor of surgery at U-M, went right into action, obtaining emergency clearance from the Food and Drug Administration to create and implant a tracheal splint for Kaiba made from a biopolymer called polycaprolactone.

On February 9, 2012, the specially-designed splint was placed in Kaiba at C.S. Mott Children’s Hospital. The splint was sewn around Kaiba’s airway to expand the bronchus and give it a skeleton to aid proper growth. Over about three years, the splint will be reabsorbed by the body. The case is featured today in The New England Journal of Medicine.

"It was amazing. As soon as the splint was put in, the lungs started going up and down for the first time and we knew he was going to be OK," says Green.

Green and Hollister were able to make the custom-designed, custom-fabricated device using high-resolution imaging and computer-aided design. The device was created directly from a CT scan of Kaiba's trachea/bronchus, integrating an image-based computer model with laser-based 3D printing  to produce the splint.

Kaiba was off ventilator support 21 days after the procedure, and has not had breathing trouble since then.

The image-based design and 3D biomaterial printing process can be adapted to build and reconstruct a number of tissue structures.  Green and Hollister have already utilized the process to build and test patient-specific ear and nose structures in pre-clinical models.  In addition, the method has been used by Hollister with collaborators to rebuild bone structures (spine, craniofacial and long bone) in pre-clinical models.

Severe tracheobronchomalacia is rare. About 1 in 2,200 babies are born with tracheomalacia and most children grow out of it by age 2 or 3, although it often is misdiagnosed as asthma that doesn’t respond to treatment.

Severe cases, like Kaiba’s, are about 10 percent of that number. And they are frightening, says Green. A normal cold can cause a baby to stop breathing. In Kaiba’s case, the family was out at a restaurant when he was six weeks old and he turned blue.

"Severe tracheobronchomalacia has been a condition that has bothered me for years," says Green. "I’ve seen children die from it. To see this device work, it’s a major accomplishment and offers hope for these children."

Kaiba is doing well, and he and his family, including an older brother and sister, live in Ohio.

______

(Image via Shutterstock)